NETGEAR GS748T manual Reset Button, Front Panel LEDs

GS748T Smart Switch Hardware Installation Guide

Table 2-1. Front Panel LEDs

Label	Color	Activity	Description
Power	Green	On	Power is supplied to the switch
		Off	Power is disconnected
		On	A valid 1000Mbps link is established on
	Green		the port
		Blinking	Data transmission is occurring at
Speed/Link/ACT			1000Mbps on the port
	Yellow	On	A valid 10/100Mbps link is established
			on the port
	None	Off	No 10/100/1000Mbps link is
			established on the port
		On	A valid 1000Mbps link is established on
SFP (MiniGBIC) Link/Act	Green		the port
		Off	No valid link is established on the port

Reset Button

The Reset button of the GS748T triggers a hardware reset of the switch. Figure 2-3shows its location on the front panel. This action is equivalent to switching the unit power off and back on. The last saved configuration is loaded into the switch as it resets. To operate the reset button, insert a device such as a paper clip into the opening to press the recessed button. The front-panel LEDs should extinguish and light again as the switch performs its Power On Self Test (POST).

Physical Description 2-3

v1.0, January 2007