NETGEAR GS108T-200NAS manual Installing the Switch on a Flat Surface, Wall Mounting the Switch

GS108T Hardware Installation Guide

Table 4-1. Site Requirements (continued)

Characteristics	Requirements
Power source	Provide a power adapter (included). Power specifications for the switch are shown in
	Appendix A . Ensure the AC outlet is not controlled by a wall switch, which can
	accidentally turn off power to the outlet and the switch.
	Alternatively, you can use IEEE802.3af-compliant power sourcing equipment (PSE) to
	supply power to the switch. Connect the PSE to Port 1 on the GS108T switch.
	When both an external power supply and a PoE source are connected to the GS108T
	switch, the external power source takes priority.
Environmental	• Temperature - Install the switch in a dry area, with ambient temperature between 0 and
	50ºC (32 and 122ºF). Keep the switch away from heat sources such as direct sunlight,
	warm air exhausts, hot-air vents, and heaters.
	• Operating humidity - The installation location should have a maximum relative
	humidity of 90%, non-condensing.
	• Ventilation - Do not restrict airflow by covering or obstructing air inlets on the sides of
	the switch. Keep at least 2 inches (5.08 centimeters) free on all sides for cooling. Be
	sure there is adequate airflow in the room or wiring closet where the switch is installed.
	• Operating conditions - Keep the switch at least 6 ft. (1.83 m) away from nearest
	source of electromagnetic noise, such as a photocopy machine.

Step 2: Installing the Switch

The GS108T Smart Switch can be used on a flat surface or mounted on the wall.

Installing the Switch on a Flat Surface

The switch ships with four self-adhesive rubber footpads. Stick one rubber footpad on each of the four concave spaces on the bottom of the switch. The rubber footpads cushion the switch against shock/vibrations.

Wall Mounting the Switch

To mount the switch on a wall (optional), install the two provided screws in positions that correspond to the slots on the bottom side of the GS108T, then mount the switch.

4-2 Installation

v1.0, January 2010