NETGEAR GS108T-200NAS manual Applying Power, Using an AC Power Source, Using a PoE Power Source

Page 22

GS108T Hardware Installation Guide

Step 5: Applying Power

The GS108T Smart Switch does not have an ON/OFF switch. You can apply or remove power by:

Connecting or disconnecting the power adapter to or from an AC power source

Connecting or disconnecting Port 1 to or from a PoE power source.

Note: When both an external AC power source and a PoE power source are connected to the GS108T switch, the external AC power source takes priority.

Using an AC Power Source

Before connecting the power cord, select an AC outlet that is not controlled by a wall switch, which can turn off power to the switch. After selecting an appropriate outlet, use the following procedure to apply AC power.

1.Connect the end of the supplied IEC AC power adapter cable to the power receptacle on the back of the switch.

2.Connect the AC power adapter cable into a power source such as a wall socket or power strip. When applying power, the Power LED on the switch’s front panel illuminates.

If the Power LED does not go on, check that the power cable is plugged in correctly and that the power source is good. If this does not resolve the problem, refer to Appendix A .

Using a PoE Power Source

The NETGEAR GS108T Smart Switch is a PoE Powered Device (PD) and can receive power from IEEE 802.3af-compliant PoE Power Sourcing Equipment (PSE). To power the GS108T Smart Switch through PoE, use the following procedures:

1.Connect a standard Cat5 UTP cable to Port 1 (also labeled PoE-PD) on the front of the switch.

2.Connect the other end of the Cat5 cable to the appropriate port on the PoE Power Sourcing Equipment (PSE).

When applying power, the Power LED on the switch’s front panel illuminates.

If the Power LED does not go on, check that the power cable is plugged in correctly and that the power source is good. If this does not resolve the problem, refer to Appendix A .

4-4

Installation

v1.0, January 2010

Image 22
Contents GS108T Hardware Installation Guide NETGEAR, IncTrademarks Contents Appendix B Technical Specifications Index About This Manual Conventions, Formats and ScopeHow to Print this Manual Revision History Part Number Version Date DescriptionViii About This Manual Chapter Introduction OverviewFeatures Package Contents GS108T Hardware Installation Guide GS108T Front and Back Panel Configuration Chapter Physical DescriptionPort LEDs Power ConnectorLED Designations DesignationSystem LEDs Powered-Device PortDevice Hardware Interfaces RJ-45 PortsReset Button Factory Defaults ButtonDesktop Switching Chapter ApplicationsApplications Characteristics Requirements Chapter InstallationPreparing the Site Installing the Switch on a Flat Surface Installing the SwitchWall Mounting the Switch Checking the Installation Connecting Devices to the SwitchUsing an AC Power Source Applying PowerUsing a PoE Power Source Managing the Switch using a Web Browser or the PC Utility GS108T Hardware Installation Guide Troubleshooting Chart Appendix a TroubleshootingSymptom Cause Solution Switch Integrity Additional Troubleshooting SuggestionsConfiguration Network Adapter CardsAuto-Negotiation GS108T Hardware Installation Guide Appendix B Technical Specifications Network Protocol and Standards CompatibilityInterface Electromagnetic Emissions GS108T Hardware Installation Guide Index NumericsIndex-2