NETGEAR FSM726 manual LED Descriptions, Console Port

LED Descriptions

The front panel of the NETGEAR Model FSM726 Managed Switch has LEDs that provide a quick and accurate display of port speed and activity. The Gigabit Ethernet ports also have LEDs that show link and mode status. Table 2-1 summarizes the LEDs on the switch and Gigabit Ethernet module.

Table 2-1. Front Panel LEDs:

Feature	Description
Power LED	Solid Green –Power is supplied to the switch & operating normally
	Off – Power is Disconnected.
24-10/100M Ports	Link/ACT LED:
Two LED /Port	Solid Green – A valid 10/100Mbps link is established on the port.
	Blinking Green – Packets transmission or reception is occurring
	on the port at 100Mbps.
	OFF –No 10/100Mbps link is established on the port.
	100M LED
	Solid Green – A valid 100Mbps link is established on the port.
	OFF –No 100Mbps link is established on the port .
2-10/100/1000M Ports	Link/ACT LED :
Two LED / Port	Solid Green – A valid 10/100/1000Mbps link is established on the
	port.
	Blinking Green – Packets transmission or reception is occurring
	on the port at 10/100/1000Mbps.
	OFF –No 10/100/1000Mbps link is established on the port.
	100/1000M LED :
	Solid Green –A valid 1000Mbps link is established on the port.
	Solid Yellow – A valid 100Mbps link is established on the port.
	OFF –No 100/1000Mbps link is established on the port.
	Note: GBIC port using TP port LED display.

Console Port

Your NETGEAR Model FSM726 Managed Switch has a console port on the front panel. This port is labeled Console and is required for initial management configuration of the switch. It also lets you manage the switch using a directly connected VT-100 terminal, personal computer (PC), Apple Macintosh, or UNIX workstation. The terminal, computer, or workstation connects to the console port using the null-modem cable supplied with your switch.

The console port is configured to use the following settings:

•Baud rate: 9,600 bps

•Data bits: 8

•Parity: none

•Stop bit: 1

•Flow control: none

These settings appear below the connector on the switch front panel.

Page 11 of 11