NETGEAR FSM726 manual Reset Button

Page 13

In addition to using the console port, you can manage the switch using a Web browser or a Simple Network Management Protocol (SNMP) management program.

Note: You must use the console port for the initial management configuration.

For more information about console-port connections, see “Connecting to the Console Port” in Chapter 3 Installation. For more information about managing the switch, see the User Manual located on the CD- ROM.

Reset Button

This recessed button on the front panel once pushed will perform a hardware reset of the switch. This is equivalent to power-cycle the switch. The reset will not change any of the switch's configuration, nor will it save any changes to the configuration. Please do not push this button if you're in the middle of downloading a new firmware.耟

Page 12 of 12

Image 13

Contents Page Statement of Conditions Internet/World Wide Web Contents Figures Overview IntroductionFeatures Page Verify that your package contains the following Package ContentsFront and Back Panels Physical Description10/100 Mbps RJ-45 Ports Gigabit Ethernet Ports RJ-45 and Gbic module bay Console Port LED DescriptionsReset Button Preparing the Site InstallationEnvironmental Checking the Installation Installing the SwitchApplying AC Power Installing the Switch on a Flat SurfaceInstalling a Gbic Module Connecting Devices to the SwitchInstalling a Gigabit Ethernet Module into an FSM726 System Information Page Network Protocol and Standards Compatibility Appendix a Technical SpecificationsManagement InterfacePhysical Dimensions Power SupplyEnvironmental Specifications Electromagnetic Immunity SafetyTroubleshooting Chart Appendix B TroubleshootingAdditional Troubleshooting Suggestions Network Adapter CardsSwitch Integrity ConfigurationAuto Negotiation Appendix C Default Settings