Installation, Preparing the Site, Environmental

CHAPTER 3: INSTALLATION

This chapter describes the installation procedures for your NETGEAR Model FSM726 Managed Switch. Switch installation involves the following steps:

Step 1: Preparing the site

Step 2: Installing the switch

Step 3: Checking the installation

Step 4: Applying AC power

Step 5: Connecting devices to the switch

Step 6: Installing a GBIC module

Step 7: Connecting to the console port to manage the switch (initial configuration)

Before you install your switch, be sure your operating environment meets the operating environment requirements in Table 3-1.

Table 3-1. Site Requirements

Characteristics	Requirements

Mounting
Desktop installations:	Provide a flat table or shelf surface.
Rack-mount installations:	Use a 19-inch (48.3-centimeter) EIA standard equipment rack that is grounded
	and physically secure. You also need the rack-mount kit supplied with your
	switch.

Access	Locate the switch in a position that lets you access the front panel RJ-45 ports,
	view the front panel LEDs, and access the rear-panel power connector.
Power source	Provide a power source within 6 feet (1.8 meters) of the installation location.
	Power specifications for the switch is shown in Appendix C. Be sure the AC
	outlet is not controlled by a wall switch, which can accidentally turn off power
	to the outlet and the switch.
Environmental
Temperature:	Install the switch in a dry area, with ambient temperature between 0
	and 40ºC (32 and 104ºF). Keep the switch away from heat sources
	such as direct sunlight, warm air exhausts, hot-air vents, and heaters.
Operating humidity:	The installation location should have a maximum relative humidity of
	90%, non-condensing.
Ventilation:	Do not restrict airflow by covering or obstructing air inlets on the sides
	of the switch. Keep at least 2 inches (5.08 centimeters) free on all sides
	for cooling.
	Be sure there is adequate airflow in the room or wiring closet where you
	intend to install the switch.
Operating conditions:	Keep the switch at least 6 ft (1.83 m) away from nearest source of
	electromagnetic noise, such as a photocopy machine.

Page 13 of 13