NComputing X550 manual Run this program only during Logon and In folder

Page 34

X550 User Guide

•Automatically turn station on when system starts: If you unset this checkbox the station (and its monitor) will not start when the system boots up. This is normally left defaulted to on; otherwise, you will have to manually start the station from this administration console.

•Enable “Shut Down” option without logging on to the station: If this is turned on, access terminal users see the shut down options in their logon window and their “Start” programs tab. This would allow the host PC to be shut down without a valid user logon. If this is turned off, the shut down options are not visible until the user logs on.

•Monitor off: An individual X550 access device station consumes less than one watt of power, but the monitor attached to it consumes many times that (50-70 watts for an LCD monitor and well over 100 watts for a CRT). Thus the X550 PCI card provides an EXTRA “energy saver” setting that is independently configurable for each access device or station.. This drop down sets the amount of time the station can be idle before the X550 puts the monitor into a sleep state. Moving the mouse or hitting a key on the keyboard attached to the corresponding access device will wake the monitor back up. Selecting the value of “Never” means that the monitor will always remain powered on. (All normal screen saver functions still apply to prevent monitor “burn.”)

•Enable “Auto Logon” mode: When this is enabled and there is an entry in the “username” and “password” fields, the specified username is automatically logged in when the station starts.

•Run this program only during Logon: and In folder:

When you select a program to run and the folder where it is located, the program is started when there is a logon using the station. (This option along with the Enable Auto Logon are often used in setting up unattended kiosk environments.)

•Initial keyboard state: These check boxes allow setting the specific keyboard states that will be active when the stations starts. There are separate settings for Num-Lock, Caps-Lock and Scroll-Lock.

In the toolbar, there is a “Stop station button:.” When you select a station and click this button, a confirmation window asks if you want to stop the selected station. It also reminds you to exit all programs and log off the station.

Page 34

Page 33 Page 35
Image 34
Page 33 Page 35
Contents X550 Desktop Virtualization Kit with vSpaceTM User Guide Important Notices Contents Safety Information Regulatory Compliance FCC InformationXD2 Access Device 제조국가 아이온 중국One Kit Enables Six Users to Share a PC Product OverviewMinimum System Requirements Host PCInstall the Hardware Install the X550 PCI CardOptional installation of a second X550 card Connect Peripheral Devices Install the NComputing vSpace Software X550 User Guide X550 User Guide X550 User Guide X550 User Guide X550 User Guide Product Registration X550 User Guide Online Registration Offline Registration X550 User Guide X550 User Guide Uninstallation and Reinstallation Updating the vSpace Software X550 User Guide Using the vSpace Console X550 User Guide Local Settings X550 PCI CardX550 User Guide X550 User Guide X550 User Guide X550 User Guide Run this program only during Logon and In folder Information & Settings X550 User Guide X550 User Guide USB-Device Assignments X550 User Guide X550 User Guide Error message Station x. stopped Warranty and TroubleshootingCan’t connect to the host PC Glossary
Related manuals
Manual 2 pages 34.52 Kb
Top Page Image Contents