HP Manager Software manual WX1200 ports support full-duplex mode only

224CHAPTER 5: CONFIGURING WX SYSTEM AND ADMINISTRATIVE PARAMETERS

7To specify the speed of a 10/100 Ethernet port, select one of the following:

„Auto — Sets the port to automatically detect the traffic speed and set the speed accordingly. This is the default value.

„10 — Sets the speed to 10 Mbps.

„100 — Sets the speed to 100 Mbps.

The port speed for gigabit Ethernet ports is predefined as 1000 Mbps and cannot be configured.

8To specify the operating mode of a 10/100 Ethernet port, select Half for half-duplex or Full for full-duplex mode.

WX1200 ports support full-duplex mode only.

9For a WX4400 gigabit Ethernet port, select the interface you want to enable.

„GBIC — Enables the fiber interface and disables the copper interface.

„RJ45 — Enables the copper interface and disables the fiber interface.

The port supports only the physical interface you select. The other interface is disabled. The port cannot dynamically switch between one interface and the other.

The PHY Media Preference drop-down list is displayed only for WX4400 ports.

10To enable SNMP link traps and 3WXM polling on the port, select SNMP Link Traps/3WXM Monitoring Enabled.

By default, this option is disabled. If you enable it, SNMP link traps are sent when the port state changes, and 3WXM also polls and monitors the port’s status. To generate the LinkDown and LinkUp SNMP traps, you must enable this option.

You also must globally enable SNMP traps. See “Configuring Logging” on page 215.

11Click Finish.

12Do one of the following:

„Go to “Configuring Load Sharing”.

„Select another item in the WX Switch wizard, if you are using this wizard.

„Click Finish to close the wizard and save changes.