HP Manager Software manual ObjectAction

Specifying the RF Characteristics of a Floor 133

Drawing RF Obstacles To draw RF obstacles, you use the Insert RF Obstacle box of the Edit Content page. Follow these steps.

1In the Insert RF Obstacle group box of the Edit Content page, click one of the following icons and draw the object as described:

ObjectAction

(circle)

(square)

(parallelogram)

(polygon)

(line)

Diagonally drag the cursor over the area where you want the circle to appear.

Diagonally drag the cursor over the area where you want the square to appear.

3WXM treats squares as one solid object when calculating RF attenuation. To draw a square outline, draw four lines in a square shape, which are treated as four separate RF obstacles.

1Click at a vertex, and drag the cursor to the next connected vertex.

2Click again, and drag the cursor until the parallelogram takes the shape you want.

3Click to finish.

1Click at a vertex, then move the cursor to the next vertex.

2Repeat until the polygon takes the shape you want.

For a polygon with n sides, click n-1additional times at the vertices. For example, to draw a 7-sided polygon, click at 6 vertices.

3At the last vertex before completing the shape, Right-click to complete the polygon.

3WXM supports concave polygons. A concave polygon contains an internal angle greater than 180 degrees.

1Click at the start of the line.

2Drag the cursor to the end of the line.

3Click to finish.

(cursor)