314CHAPTER 7: CONFIGURING AUTHENTICATION, AUTHORIZATION, AND ACCOUNTING PARAMETERS

Creating a Layer 4 Protocol ACE

To create a Layer 4 Protocol ACE:

1In the ACL Setup page of the Create ACL wizard, click New. A list of ACEs appears.

2Select New L4 Protocol ACE. The Create L4 Protocol ACE dialog box appears.

3In the Action list, select Permit to allow access if the conditions in the ACE are matched, or Deny to refuse access if the conditions are matched.

4If you select Permit, in the CoS box, specify a class-of-service level for packets. For information, see step 4 in “Creating an IP ACE” on page 309.

5To enable counting of packets filtered by an ACL, select Enable Hit Count.

6Define the IP attributes (source and destination IP addresses, the TOS, and the precedence). The steps are the same as the steps when configuring an IP ACE. See step 6 on page 309 through step 9 on page 310.

7In the Protocol ID box, specify the IP protocol number. Table 26 lists commonly used IP protocol numbers.

Table 26 Commonly Used IP Protocol Numbers

IP Protocol Number

Protocol

 

 

1

Internet Control Message Protocol (ICMP)

2

Internet Group Management Protocol (IGMP)

6

Transmission Control Protocol (TCP)

9

Any private interior gateway (used by Cisco for Internet

 

Gateway Routing Protocol)

17

User Datagram Protocol (UDP)

41

IPv6

46

Reservation Protocol (RSVP)

47

Generic Routing Encapsulation (GRE)

50

Encapsulation Security Payload for IPSec (IPSec-ESP)

51

Authentication Header for IPSec (IPSec-AH)

55

IP Mobility (Mobile IP)

88

Enhanced Interior Gateway Routing Protocol (EIGRP)

 

 

Page 314
Image 314
HP Manager Software manual Creating a Layer 4 Protocol ACE, Commonly Used IP Protocol Numbers