HP Manager Software manual Setting NTP Properties, Creating NTP Servers, Click New NTP Server

232CHAPTER 5: CONFIGURING WX SYSTEM AND ADMINISTRATIVE PARAMETERS

Setting NTP Properties

To set NTP properties:

1Do one of the following:

„Open the WX Switch wizard, then select NTP under IP Services in the organizer list of the System and Administrative page.

„In the Organizer panel, select IP Services under a WX switch, then select Config > Edit. The Modify IP Services wizard appears. Click on NTP at the top of the wizard.

2To enable NTP, select Enabled. To disable NTP, clear Enabled. By default, NTP is disabled.

3If you disabled NTP in step 2, go to step 5. Otherwise, go to the next step.

4To set the interval at which an NTP server is polled, specify its value in seconds (16 to 1024) in the Update Interval box. The default is 64 seconds.

5Do one of the following:

„Go to “Configuring ARP”.

„Select another item in the WX Switch wizard, if you are using this wizard.

„Click Finish to close the wizard and save changes.

Creating NTP Servers

To create an NTP server:

1Do one of the following:

„Open the WX Switch wizard, then select NTP under IP Services in the organizer list of the System and Administrative page.

„In the Organizer panel, select IP Services under a WX switch, then select Config > Edit. The Modify IP Services wizard appears. Click on NTP at the top of the wizard.

2Click on a row in the NTP Server IP Address column.

3Click New NTP Server.

4Edit the IP address.

5To add more NTP servers, repeat for every server. You can add a total of three NTP servers.