HP Manager Software manual Configuring IP Services

226CHAPTER 5: CONFIGURING WX SYSTEM AND ADMINISTRATIVE PARAMETERS

5To add a port to the port group, select the Member checkbox for the port. The port group name appears in the Port Group column for the port.

6To remove a port from a port group, clear the Member checkbox for the port.

7To change the membership of a port that is in another port group, select the Member checkbox for the port.

The Port Group Member Remove dialog box appears. Click Yes to change the port’s membership. Click No to leave the membership unchanged.

8Click Finish to save the changes.

9Do one of the following:

„Go to “Configuring IP Services”.

„Select another item in the WX Switch wizard, if you are using this wizard.

„Click Finish to close the wizard and save changes.

Configuring IP

Services

Configuring Static Routes

You can configure the following IP services:

„Static routes (See “Configuring Static Routes” on page 226.)

„IP aliases (See “Configuring IP Aliases” on page 229.)

„Domain Name System (DNS) service (See “Configuring DNS” on page 230.)

„Network Time Protocol (NTP) service (See “Configuring NTP” on page 231.)

„Address Resolution Protocol (ARP) entries (See “Configuring ARP” on page 233.)

The IP routing table contains routes that MSS uses for determining the interfaces for a WX switch’s external communications. When you add an IP interface to a VLAN that is up, MSS automatically adds corresponding entries to the IP routing table.