Locating and Fixing Coverage Holes 461

„Install new MAPs and add them to the network plan. Using this method, you install the new MAP first, then integrate it into your network plan.

Computing and The procedure for computing and placing new MAPs is the same as the Placing New MAPs procedure you use for initial planning. Make sure you lock the existing

MAPs in place before you compute and place the new MAPs. (See “Computing MAP Placement” on page 152.)

Adding New MAPs If you installed a new MAP in the network and you want to add it to the that Are Already network plan, do the following:

Installed to the

Network Plan

1Use the Network Verification tab to upload the MAP configuration into 3WXM. (See “Verifying Configuration Information” on page 327.)

2In the Organizer panel, right-click on the floor and select Properties. The Floor wizard appears.

3Click Plan RF Coverage at the top of the wizard. The Plan RF Coverage page appears.

4In the Coverage Areas section, right-click on the coverage area for which the MAP is providing coverage, and select Edit Properties. The Modify Coverage Area wizard appears.

5Click Area Associations at the top of the wizard.

6Click Choose Available next to the Access Point List group box, and select the MAP.

7Click Finish to save the changes and close the wizard.

8Click on Objects to Place.

9Click on the MAP icon, then click on the location where you installed the MAP. The MAP icon moves from the Objects To Place tab to its location on the floor.

Page 461
Image 461
HP Manager Software manual Installed to Network Plan