HP Manager Software manual Configuring WX System and Administrative Parameters

206CHAPTER 5: CONFIGURING WX SYSTEM AND ADMINISTRATIVE PARAMETERS

5Do one of the following:

„Go to “Enabling HTTPS”.

„Select another item in the WX Switch wizard, if you are using this wizard.

„Click Finish to close the wizard and save changes.

Enabling HTTPS By default, HTTPS is enabled on the WX, allowing you to use Web Manager on port 443 for a secure session. If you disable HTTPS, you cannot use Web Manager.

Enabling or disabling HTTPS does not affect 3WXM secure communications. However, WebAAA and Web Manager require the HTTPS server to be enabled.

To enable or disable HTTPS access:

1Do one of the following:

„Open the WX Switch wizard, then select HTTPS, Telnet, SSH & Web Portal under Management Services in the organizer list of the System and Administrative page.

„In the Organizer panel, select Management Services under a WX switch, then select Config > Edit. Click on HTTPS, Telnet, SSH & Web Portal at the top of the wizard.

2Select Enabled to enable HTTPS access, or clear Enabled to disable HTTPS access.

3Do one of the following:

„Go to “Configuring Telnet”.

„Select another item in the WX Switch wizard, if you are using this wizard.

„Click Finish to close the wizard and save changes.