HP Manager Software manual To configure WPA or RSN encryption choices

244CHAPTER 6: CONFIGURING WIRELESS PARAMETERS

Rather than type the preshared key, you can specify a passphrase that is used to generate a preshared key.

„In the Pre-shared Key box, type an alphanumeric passphrase (8 to 63 characters).

„Click Generate Key. The preshared key appears in the Pre-shared Key box.

5Go to “To configure WPA or RSN encryption choices”.

To configure WPA or RSN encryption choices

1To enable the 40-bit WEP cipher suite, select WEP-40 Enabled.

To disable it, clear WEP-40 Enabled. By default, this option is not enabled.

2To enable the 104-bit WEP cipher suite, select WEP-104 Enabled.

To disable it, clear WEP-104 Enabled. By default, this option is not enabled.

3To enable the TKIP cipher suite, select TKIP Enabled.

To disable it, clear TKIP Enabled. By default, the TKIP cipher suite is enabled.

4After enabling the TKIP cipher suite, type the TKIP countermeasures time in the TKIP Countermeasures Time box.

By default, TKIP countermeasures are used for 60,000 ms (60 seconds) after a second MIC failure within a one-minute interval.

5To enable the AES-CCMP cipher suite, select AES (CCMP) Enabled.

To disable it, clear AES (CCMP) Enabled. By default, this option is not enabled.

6Do one of the following:

„To map this service profile to a radio profile that is already configured, see “Mapping a Service Profile to a Radio Profile”.

„To configure a new radio profile, see “Configuring a Radio Profile” on page 245.

„To close the wizard and save the changes, click Finish.