HP Manager Software manual Configuring Directly Connected MAP Access Points

Configuring Directly Connected MAP Access Points 257

To modify a MAP You can change connection parameters for a MAP, including the WX connection port (for directly connected MAPs).

For MAP models that have two Ethernet ports, you also can add or change the second WX connection for redundancy.

1On the MAP page of the Wireless page of the WX Switch wizard, select a MAP port, then click Modify MAP. The Modify MAP wizard appears.

2Select the connection you want to change and click Modify. The Modify Direct Connection or Modify Distributed Connection dialog box appears, depending on the connection type.

3Modify connection parameters:

a To change the WX switch for the connection, select the WX switch from the WX pull-down list.

b To change the MAP port number or Distributed MAP connection number, select the new value from the Port or DAP Number pull-down list.

c To change the connection bias, select the new value from the Bias pull-down list.

d To add the MAP to a MAP group for session load balancing, type the group name in the Load Balance Group box.

4Click Finish to close the dialog.

5Click Finish again to save the changes and close the Modify MAP or Modify Distributed MAP wizard.