Kohler 15ERG, 13ERG, 10ERG manual E d 0 B t 1, C n 0 S A V E, S A V E U u 0, Y E S

Pressing the up arrow key at the Adnc display (See Figure 8-9) puts you into the Advanced Configuration Mode.

Press:

or To set the engine data input type.

To enter battery voltage selection mode.

or To toggle between 12 and 24 VDC.

To enter communications selection mode.

E d 0 x

B t 1 2

To set the communications parameter.

or

To enter SAVE mode. Go to Figure 8-11.

C n 0 x

S A V E

Note: Shaded boxes show which number in the controller display changes when the up or down arrow key is pressed. “x” denotes any number from 0 to 9.

Note: Be sure to save your settings before exiting the configuration mode. The controller reverts to the last saved settings when the master switch is moved to the OFF/RESET position.

Figure 8-10 Advanced Configuration Mode (engine data input types, battery voltage, and engine communications)

There are 3 options when the display says SAVE:

Press:

To return to the first parameter, system voltage/frequency Uu, to check or change settings before saving. See Figure 8-9.

or

S A V E

U u 0 x

To save changes.

or

Y E S

To discard changes without saving. n o

“Yes”or “no” flashes when the up or down arrow is pressed and then

the controller exits the configuration mode. The display returns to x x x x the runtime hours.

* x in the runtime hours display above denotes any number from 0 to 9.

Now move the master switch to OFF/RESET.

Figure 8-11 Save Mode (after configuring generator set parameters)

TP-6335 9/04 Reconnection/Adjustments 35