Multi-Tech Systems ISIHP-2U, ISIHP-2S quick start AT Commands, ConfigMenu Menus

Software/Driver Installation

ConfigMenu Menus

Network Configuration Menu—configures network parameters such as switch type, data and voice TEIs, and data and voice MSNs. When you finish, select Save Network Configuration to save your work.

Call Control Configuration Menu—changes how the TA originates and answers calls. Options include Auto Answer, Rings to Answer, Dialing Method, and Persistent DTR Dialing.

Data Protocol Menu—changes rate adaption protocol used by the TA.

Stored Numbers Menu—stores up to ten phone numbers ( maximum of 20 characters each). Stored number 0 is the phone number that will be dialed if persistent DTR dialing is enabled.

Port Control Configuration Menu—configures TA’s serial port, including how TA responds to control signals on the serial interface.

Help Menu—provides assistance in navigating through the TA menu system or viewing the ISIHP-2S/2U’s firmware version numbers.

AT Commands

You can configure the terminal adapters using AT commands, just as you would configure an analog modem. Use this method if you prefer to work with AT commands or if you have a special requirement not addressed by either of the configuration utilities.

To configure the TAs with AT commands:

1.Disconnect the ISIHP-2S/2U from the network (remove RJ-45 cables from ISDN jacks).

2.Start a data communication program and select the first and third COM ports to be configured.

3.Referring to records made for your system, enter AT commands in the terminal window of the data communications program.

4.When you finish, use the &W command to save your new configuration and to select it to load automatically when the ISIHP- 2S/2U is turned on.

5.Close the data communications program and reconnect the TA to the network terminator.

For more information, see the online Owner’s Manual.

MultiModemISI Hybrid Series, ISIHP-2S/2U 51