MicroNet Technology SP616DB, SP624DB TX/FX Push Button, IP Reset Push Button, Port Status, LEDs

POWER

This LED comes on when the switch is properly connected to power and turned on.

TX/FX Push Button

The push button is located at the right side of port 16 (SP616DB) or port 24 (SP624DB). Release this button to use RJ-45 port 16 (SP616DB) or port 24 (SP624DB), and press this button to use the 100BASE-FX module.

IP RESET Push Button

Press the front panel IP RESET push button for around five seconds to reset the Switch back to default IP Address (192.168.1.10).

Port Status

The RJ-45 ports are numbered from 1 to 16 (SP616DB), or from 1 to 24 (SP624DB).

LEDs

Label		Status		Indication
POWER		On		Power is feeding in.
		Off		Power is switched off.
				Improper connection.
CONSOLE	LNK	On		A valid network connection. LNK stands for LINK.
		Off		No connection.
	ACT	Flashing	Transmitting or receiving data. ACT stands for
				ACTIVITY.
		Off		Neither connection nor activity.
PORT	LNK/ACT	On		A valid network connection. LNK stands for LINK.
		Flashing	Transmitting or receiving data. ACT stands for
				ACTIVITY.
		Off		Neither connection nor activity.
	SPEED	On		A valid 100Mbps connection.
		Off		A valid 10Mbps connection.
FX	LNK	On		A valid network connection. LNK stands for LINK.
		Off		No connection.
	ACT	Flashing	Transmitting or receiving data. ACT stands for
				ACTIVITY.
		Off		Neither transmitting nor receiving data.

Table 1: SP616DB/SP624DB LED Indication

3