MicroNet Technology SP624DB, SP616DB Installation, Preparing the Site, Settling the Switch

Page 4

Installation

Preparing the Site

Select the site that meets the following requirements:

Characteristic

Requirement

Temperature

32 to 104˚F (0 to 40˚C)

 

 

Humidity

Maximum relative humidity of 90%, non-condensing

 

 

Condition

At least 1.8 meters (6 feet) to the nearest source of electromagnetic noise

 

 

Ventilation

Minimum 3 inches (0.25 feet) of clearance around the ventilation openings

 

 

Power Outlet

Within 1.8 meters (6 feet) to the switch

 

 

Table 2: SP616DB / SP624DB Operating Requirements

Settling the Switch

zMounted to 19-inch standard rack

Locate the accessories provided in the product package. Use the rack-mount brackets and screws to install the switch into any EIA 19” standard rack.

Step 1: Attach the brackets to each side of the chassis.

Step 2: Apply the screws to each side and secure them tightly.

Step 3: Carefully position the switch into the rack.

Step 4: Align the brackets to the side holes on the rack and use rack screws to secure the chassis with the rack.

Step 5: Proceed to the “Connecting to Power” section.

zDesktop or any flat surface

The switch can sit on desktop or any flat surface with adequate space and ventilation. If you want to place it onto a shelf, make sure the shelf can withstand the weight of the switch. Step 1: Simply put the switch on the desired place.

Step 2: Ensure the switch receives good ventilation.

Step 3: Proceed to the “Connecting to Power” section.

Installing the Module (optional)

Consult the following illustrations for installation.

Figure 3: Removal of cover plate

Figure 4: Fiber module being installed

Step 1: Make sure the power is switched off. The module is not hot-swappable.

It may cause electric shock or any possible damage to the switch if the power is not switched off.

4

Image 4
Contents EtherFast 10/100M Smart Switch Features Package ContentsPhysical Description IP Reset Push Button TX/FX Push ButtonPort Status LEDsInstallation Settling the SwitchInstalling the Module optional Preparing the SiteConnecting to Power Connecting to NetworkSetting UP Console Port Connection Switch ConfigurationMain Menu Main menu System ChangeIP Configuration PortVlan Trunk Save Configuration Click Save ConfigurationLoad Default Click Load DefaultSpecifications