MicroNet Technology SP907NL user manual Connect to Access Point

If users cannot see the access point, please click ‘Rescan’ button to scan for access point again, until the one preferred is displayed on the interface. Users may have to click ‘Rescan’ for more than two times before the access point wish to connect appears. If user still cannot see the access point after clicking ‘Rescan’ for more than five times, please move the computer closer to the wireless access point.

If users wish to see detailed information for a specific access point, please double-click on it, and detailed information will be provided.

Parameter	Description
General	Displays basic information about this access point, such as
	SSID, MAC Address, authentication / encryption type,
	channel etc.
WPS	If this access point supports WPS (Wi-Fi Protected Setup),
	related information will be displayed here.
CCX	If this access point supports CCX (Cisco Compatible
	eXtension), related information will be displayed here.
802.11n	If this access point complies with 802.11n draft, related
	information will be displayed here.
Sorted by >>	Users can decide how to sort all listed access point by ‘SSID’,
	‘Channel’, or ‘Signal’ (signal strength).
Show dBm	Check this box to show the signal strength of access point,
	instead of percentage.
Rescan	Click this button to rescan access points. Users can click this
	button for several times, if the access point users wish to use
	does not show in the list.
	Users can store a specific access point to profile, so access
	point can be directly connected next time, without inputting
Add to Profile	authentication key again. To add an access point to profile,
	users have to select an access point from the list first, then
	click ‘Add to Profile’ button. Detailed instructions will be given
	below.
Connect	Connect to a selected access point. Users have to select an
	access point from the list first and then click ‘Connect’ to
	connect to the selected access point.

3.2.2 Connect to Access Point

If the wireless access point users wish to connect is found, it can establish connection by clicking on ‘Connect’ button. Instructions will be given as follow:

11