OPERATING GUIDE.
Figure 3 The Hyperterminal
6.Press Enter. Some device information and a prompt appear.
7.Type config and press Enter. Configuration questions appear. DHCP can be enabled or disabled. You can change the IP address, net mask and default gateway. Pressing Enter without entering values keeps the default values. To contact Smart 16 IP from outside the LAN configure a gateway. To remove an already configured gateway, type 0.0.0.0.
The last question – enable IP access control – concerns switching IP packet filtering on or off. This can
8.Confirm the settings, Smart 16 IP resets the configuration.
(B)Use a crossover Ethernet cable to connect the Smart 16 IP to the computer
Set the IP address of the computer to 192.168.1.20 and type 192.168.1.22 into the Address box of the web interface to carry out the IP configuration.
5. Mouse, Keyboard and Video configuration
The correct operation of the client mouse depends on the following two settings.
Smart 16 IP mouse setting
To make the remote keyboard and mouse work properly the Smart 16 IP settings for the host's mouse and keyboard types must be correct. Check the settings in the Smart 16 IP Web interface. See page 20.
6