N-Tron 702M12-W user manual Router Mode, Mulitcast Routing Settings

Page 34

Router Mode

IP Address: This is the IP address to be represented by the wireless interface of the 702-W.

Netmask: This is used to define the host and device classification for the chosen IP address range. 255.255.255.0 is a typical value.

Enable NAT: Network Address Translation (NAT) enables packets to be sent from the outside world to the wireless interface IP address and then sub-routed to other client devices residing on its local network.

Enable DHCP Server: Dynamic Host Configuration Protocol (DHCP) Server assigns IP addresses to clients who will associate to the wireless interface.

Range Start/End: This range will determine the IP addresses given out by the DHCP server to associated client devices.

Netmask: DHCP Netmask

Lease Time: The IP addresses given out by the DHCP server will only be valid for the duration specified by the lease time. Increasing the time ensures client operation without interrupt, but could introduce potential conflicts. Lowering the lease time will avoid potential address conflicts, but may cause slight interruptions to the client while re-acquiring a new IP addresses from the server.

Port Forwarding: Port forwarding allows specific ports of the WLAN IP address to be forwarded to different IP addresses on the same network. This is useful for applications such as FTP servers, HTTP servers, etc. where different host systems want to be seen using a single common IP address.

PPPoE: Point-to-Point Protocol over Ethernet (PPPoE) is a virtual private and secure connection between two systems which enables encapsulated data transport. It is commonly used as the medium for subscribers to connect to Internet Service Providers.

Enable DMZ: The Demilitarized zone (DMZ) can be used as a place where services can be placed such as Web Servers, Proxy Servers, and E-mail Servers such that these services can still serve the local network and are at the same time isolated from it for additional security.

MULITCAST ROUTING SETTINGS

With a multicast design, applications can send one copy of each packet and address it to the group of computers that want to receive it. This technique addresses packets to a group of receivers rather than to a single receiver, and is dependent on the network to forward the packets to only the networks that need to receive them.

Revision 04062009

Page 34 of 52

Image 34
Contents Revision Revision Product Features Wireless Compliance Revision Environmental Safety Electrical Safety Safety WarningsGeneral Safety Warnings Contact InformationCleaning InstallationUnpacking Ingress Protection IP67 DIN-Rail Mounting DIN Rail MountingUniversal Rack Mounting 702M12-W Bulkhead Mounting 702M12-W Pole KIT Mounting LNK/ACT Front PanelLED PWRApplying Power 702-W Side View Applying Power 702M12-W Connecting the Unit RJ45 Connector Crimp SpecificationsTron Switch Grounding Techniques FCC Statement TroubleshootingSupport Industry CanadaWeb Management and Configuration Configuration Guide NavigationSystem Info System Information Revision Statistics Reporting Extra Info Revision Tools Site Survey can be updated using the Scan button Basic Wireless Settings Station WDS mode enables packet forwarding at layer 2 levelRevision 802.11NG 20MHz 802.11NG 40MHz 802.11NA 20MHz 802.11NA 40MHz Wireless Security Revision Bridge Mode NetworkRevision Router Mode Mulitcast Routing SettingsAdvanced Wireless Settings AdvancedAcknowledgment Timeout Antenna Alignment LED ThresholdsWireless Traffic Shaping Service Ping WatchDogSnmp Agent NTP Client, Web Server, Telnet Server Firmware Host NameDevice Maintenance Administrative AccountConfiguration Management Interface LanguageCommon Topology Scenarios Scenario 1 Basic BridgeScenario 2 Encrypted Bridge Scenario 3 Controls Network LANScenario 4 WDS Peering AP1 AP2Scenario 5 Broadband Modem Wireless Router W/ Dhcp LANKey Specifications Regulatory Approvals 702M12-W Key Specifications Regulatory Approvals Tron Limited Warranty