Configuring and Connecting AC Power
Be sure to follow the instructions in this section for the proper configuration of fuses and voltage settings.
DSM1 speakers must be manually config- ured for the voltage in your area. Always check the voltage setting and fuse rating, as described below, before connecting and powering your speakers.
Setting the Voltage
Make sure the Voltage Selector setting on each speaker matches your local voltage
Voltage selector
Voltage selector
Installing a Fuse
A 2.5 Amp fuse is required for both the
Make sure to use a fuse rated at 2.5 Amps. Do not use fuses of any other rating, or you risk damage to the unit
To change the fuse:
1Turn off power to the speaker and disconnect the AC power cord.
2Use a small screwdriver to remove the fuse holder.
Fuse holder
Fuse holder
3Remove the currently installed fuse.
4Install the new fuse in the fuse holder.
5Replace the fuse holder so that it clicks into place.
Chapter 3: Setup and Operation 9