Connecting Power
To connect power to the speakers:
1Make sure you have set the Voltage Selector and installed the proper fuse before proceeding. (See “Setting the Voltage” on page 9 for details.)
2Connect the included AC power cord to the AC connector on the back panel of each speaker (one power cord is included with each speaker).
AC connector
AC connector
3Connect the other end of the AC power cord to your power source.
Power Up and Power Down
Always power up your speaker system last (al- lowing mixers, recorders and other devices to fully power up first).
Conversely, always mute (or power off) your speaker system first, before powering off other devices in your studio.
Connecting Audio
This section explains how to make analog and digital audio connections to DSM1 speakers.
Connecting Analog Inputs
Analog Input (XLR)
Analog Input (TRS)
Input Sensitivity switch
Analog input section
To connect an analog source:
1Do any of the following:
•Connect a balanced XLR cable to the XLR In connector on the back panel of the speaker.
•Connect a balanced
If you need to connect an unbalanced ana- log source, see “Analog Inputs” on page 4.
2Connect the other end of the cable to the an- alog audio source (for example, an analog out- put from your monitoring system).
10