Liebert GXT 2U user manual RACK-MOUNT UPS Conversion and Installation

Installation

4.3RACK-MOUNT UPS CONVERSION AND INSTALLATION

NOTE

When rack mounted, the UPS must be supported by a shelf, brackets or slide rails on each side. The rack mount handles WILL NOT support the weight of the UPS. They are used to move the UPS into and out of the rack.

1.For slide rail installations, first remove the top/side fin. Slide the top/side fin forward, then lift it up to remove. If desired, install the optional rack mount handles that were shipped with the UPS.

UPStation GXT
– +
AC INPUT	BATTERY UPS ON
		BYPASS

Optional rack mount handles

Securing hardware and slide rails are sold separately. Contact your local dealer or Liebert representative for these additional options and any assistance needed.

2.Unpack the two (2) rack- mounting bracket assemblies and mounting hardware from the rack-mounting kit (P/N: RMKIT18-32). Bracket assemblies are interchangeable between left-hand or right-hand. Remove inner member of each bracket assembly as shown at right by extending it to its outermost position, depressing the retaining latch and then pulling inner member from bracket assembly.

Retaining latches

Inner members

Return flanges

Rear members

Front members

9