Liebert 2700VA, 208V user manual Prepare the UPS or battery cab Inet the equipment for rack

5. Prepare the UPS or battery cab-	M4
inet (the “equipment”) for rack	screws
mounting by following instruc-
tions in the equipment’s user
manual. The equipment may
require additional parts to be
added or parts to be removed
for rack mounting. After it is pre-
pared, lay equipment in rack-
mounting position. Fasten inner
members from Step 2 to the
equipment on both sides as	Front
shown in the figure at right with

(8) M4 screws provided in this kit. Make sure retaining latch is near the rear of the equipment as shown in the figure at right.

6.Open grease packet pro- vided in this kit. Apply a 1"

long bead of grease four	UPS or
(4) places inside the bot-	battery
tom, curved tracks of front	cabinet
members as shown at
right. The grease will allow
the equipment to slide into
the bracket assemblies
more easily.

Retaining latch

UPS or battery cabinet

M4 screws

Apply grease

Apply grease (inside)

! CAUTION

Lifting equipment into rack may be a two-person job, depending on weight of equipment. See equipment’s user manual.

7.Insert the equipment, with inner members attached from Step 5, into bracket assemblies by inserting top and bottom edges of inner mem- bers into the top and bottom, curved tracks of front members and slid- ing the equipment into rack (see figure in Step 6). Ends of inner members are tapered to allow rear of the equipment to be angled upward before insertion, if space allows.

Then the rear, bottom edges of inner members can be placed into front edge

of bottom tracks, and the front of the equipment can be tipped up into hori- zontal position to insert the top edges of inner members before sliding the equip-

ment into rack (see figure at right). The equipment should move smoothly into bracket assemblies. If not, recheck alignment of front and rear members from Steps 3 and 4.

11