LevelOne IPS-0008 user manual

Page 17

The following procedure describes the basic steps needed to set up the IPS-0008:

1.To set up the hardware, connect power to the power inlet and output devices to the power outlets. Connect digital outputs to the digital I/O ports, and an EMD to the console port.

2.To configure the IPS-0008, you can use the console or WAN port. Connect the IPS-0008 to a console and a WAN to enable its configuration through the console or browser menu.

3.After connecting to a console, use a console application such as Tel- net or HyperTerminal to access the console menu. Select the System Group submenu under the IPS-0008 Configuration to set up the IP address and the system date/time. This IP address will be used while accessing the web interface to configure the IPS-0008 parameters.

4.After connecting to WAN, open a browser from a PC in the network and use the IPS-0008 IP address specified through the console menu to open the web interface for system configuration.

The following sections provide instructions about how to make various connections.

13

Image 17

Contents IPS-0008 IP Power Switch User Manual Copyright information PrefaceAbout this manual Safety instructions USING THE WEB INTERFACE Table ContentUSING THE CONSOLE MENU 1. Introduction 1.1. Features 1. IPS-0008 IP Power Switch 2. Rack-mount Brackets 3. U-type Handle 1.2. Package contents8. Rubber Feet 9. Quick Installation Guide 10. Power Cord 4. U-type Handle Screws 5. Bracket Screws 6. Feet Screws 7. CD Manual1.3.1. Front Panel 1.3. Hardware ComponentsComponent DescriptionDescription Status Indicator 1.3.2. Status IndicatorCurrent level indicator Outlet power indicatorInput power consumption Remote control mode 1.3.3. Using the control buttons220AC Model 110AC Model Power on/off mode1.4. Rear Panel Rear Panel Component 2.2. Attaching the ears 2. Getting Started2.1. Attaching the feet 2.3. Making Connections Page 2.4. Connecting Input Power 2.6. Connecting digital outputs 2.5. Connecting Output Devices2.7. Connecting EMD 2.8. Connecting The Console 2.9. Connecting To a WAN 3.1. Using HyperTerminal 3. Using the Console MenuPage The main menu options are displayed 3.2. Navigating Through the Console Menu The console menu consists of the following submenus 3.3. Setting the IP Address 4.1. Overview 4. Using the Web Interfaceƒ Each menu page provides online help to assist you in configuring 4.2.1. Setting the Date and Time 4.2. Modifying the Basic Settings4.2.2. Adding Users 4.2.3. Changing Event Alert Settings Page 4.3.1. Setting Control Options 4.3. Modifying Application Settings4.3.2. Setting Up a Schedule 4.3.3. Status 4.3.4. ConfigurationPage 4.4. Power Cycle Power Input/Output SpecificationsDimensions and Weight AppendixError code Description Error codesFCC Statement Regulatory information