Bp Station PRE-SET Memories

panel will flash during Pre-Set Scan operation). Press the button again momentarily to stop Pre-Set Scan operation and remain on the selected frequency. If no buttons are pressed during the scan, the unit will return to the original station before the scan was started.

Pressing and holding the button for longer than 2 seconds will activate the Auto-Store (AST) Tuning feature which will automatically scan and enter up to 6 local area stations into the pre-set memories on the band in use. If you have already set the pre-set memories to your favorite stations, activating the Auto-Store Tuning feature will erase those stations and enter the new local ones. This feature is most useful when traveling in a new area where you are not familiar with the local stations.

To set any of the 6 pre-set memories in each band, use the following procedure:

1.Turn the radio on and select the desired band.

2.Select the first station to be pre-set using the TUN/TRK/SEK or Auto-Store (AS) Controls.

3.Press the pre-set button to be set and continue to hold it in for approximately 2 seconds. The pre-set number (CH 1-6) will appear on the display panel, indicating that the station is now set into that pre-set memory position. The station can now be recalled at any time by pressing that button.

4.Repeat the above procedure for the remaining 5 pre-sets on that band and for the other 4 bands on the unit.

bq PROGRAM 1 - 3 (P1 - P3) SELECTION

Rather than provide a fixed equalization factor for each type of -6-

broadcast (Pop, Classical or Rock) being listened to, a personalized equalization factor can be programmed for particular listening preferences. For example, P1 can be used for popular program selections, while P2 or P3 can be used for classical or rock program selections. To program an equalization factor using P1, proceed as follows:

1.Using the SEL (S) button, select the volume display (VOL) and set the sound to the desired level using the VOL / buttons.

2.Next, while VOL is still displayed, press and hold the P1 button until P_1 appears to the left of the VOL display. The volume level is now pre-set for the current type of broadcast.

3.Repeat step 1, except select the desired treble (TRE) level for the current broadcast and set this level using the VOL

/ buttons. While TRE is displayed, press and hold the P1 button until P_1 appears to the left of the TRE display. The treble level is now pre-set for the current type of broadcast.

4.Repeat step 1, except set the desired bass (BAS) level for the current broadcast and set this level using the VOL

/ buttons. While BAS is displayed, press and hold the P1 button until P_1 appears to the left of the BAS display. The bass level is now pre-set for the current type of broadcast.

5.Repeat step 1, except set the desired balance (BAL) between the left and right speakers for the current broadcast, and

set this level using the VOL / buttons. While BAL is displayed, press and hold the P1 button until P_1 appears to the left of the BAL display. The speaker balance is now pre-set for the current type of broadcast.