Lantronix 900-603 manual Ethernet LEDs, Status LED, Left LED, Right LED

2: Installation

Ethernet LEDs

There are two LEDs located on the upper left and right corners of the Ethernet socket (see Figure 2-1). These indicate the status of the connection.

Left LED

Green ON, 100Mbps Ethernet Link

Green Blinking, 100Mbps Activity

Orange ON, 10Mbps Ethernet Link

Orange Blinking, 10Mbps Activity

OFF, No Ethernet Link

Right LED

Always OFF

The Ethernet port can connect to an Ethernet (10Mbps) or Fast Ethernet (100Mbps) network.

Status LED

The Status LED on the xPrintServer device is incorporated into the “X” letter of the Lantronix logo on the top of the device. The behavior of this LED indicates the type of activity occurring in the xPrintServer device. The Status LED color is orange when lit, and specific display patterns indicate the specific type of activity. The LED may display a solid light, display no light, slowly glow on, slowly glow off, or flash on/off.

	Table 2-1 Status LED, Top of Device
Orange “X” LED	Description,
Solid	A continuous solid light indicates the power is on or the device is booting.
OFF	No light indicates the power is off.
Blinking	Even blinking pattern indicates the device is printing.
Glow / Dim	Pulsating pattern of glowing and dimming light cycle occurring once every three
(Repeating Pattern)	seconds. Indicates the device is booted, idle and waiting for a job.
Code 1	A repeating pattern of a single flash followed by two seconds	Note: Codes 1
	of no light indicates the device is obtaining the DHCP address.
		through 7 indicate
		a grouped
Code 2	A repeating pattern of two flashes followed by two seconds of
		number of flashes
	no light indicates there are no configured printers.
		in the Orange “X”
		LED separated by
Code 3	A repeating pattern of three flashes followed by two seconds of
	no light indicates a factory default reset.	a two second
		interval where the
Code 4	A repeating pattern of four flashes followed by two seconds of	light is off. The
	no light indicates a successful firmware update.	specific
		code/number of
Code 5	A repeating pattern of five flashes followed by two seconds of
		flashes separated
	no light indicates a failed firmware update.
		by a two second
Code 6	A repeating pattern of six flashes followed by two seconds of	no-light interval
		indicates a
	no light indicates a printing error.
		specific status as
Code 7	A repeating pattern of seven flashes followed by two seconds	described in the
	of no light indicates printer discovery is in process.	grey cells to the
		left.

xPrintServer User Guide 10