LevelOne FSW-1670TX, LevelOne 8+8 POE 10/100 Mbps Web Smart Switch user manual Login

Page 26

how to configure the Switch to enable its smart functions including:

Port Setting (Speed/Disable, Flow Control and Port Bandwidth Rate Ingress/Egress)

VLAN Setting (802.1Q VLAN) Trunking

Port Mirroring

QoS Setting

PoE Setting System Setting

Device status and Statistic

Login

Before you configure this device, note that when the Web Smart Switch is configured through an Ethernet connection, make sure the manager PC must be set on same the IP network. For example, when the default network address of the default IP address of the Web Smart Switch is 192.168.0.1, then the manager PC should be set at 192.168.0.x (where x is a number between 2 and 254), and the default subnet mask is 255.255.255.0.

Open Internet Explorer 5.0 or above Web browser.

Enter IP address http://192.168.0.1 (the factory-default IP address setting) to the address location.

Figure 12.

22

Image 26

Contents LevelOne FSW-1670TX Page Table of Content Installing the Web Management Utility Terms/Usage About this GuidePurpose Page Introduction Fast Ethernet TechnologySwitching Technology Power over Ethernet PoE Vlan Virtual Local Area NetworkFeatures Unpacking Unpacking and InstallationInstallation Mount the Switch in the rack Rack MountingConnecting Network Cable AC PowerPage Identifying External Components Front PanelRear Panel Ethernet Ports Port 9~16Ports 1~8 PoE port status LEDs Understanding LED IndicatorsPower and System LEDs Ports 9~16 Ethernet port status LEDs 100MbpsConfiguration Installing the Web Management UtilityDiscovery List Monitor List System word definitions in the Discovery ListPage Device Setting Toolbar Configuring the Switch Login Device Status Setup Menu Configuring Setup SettingPort Settings Vlan Settings Virtual Local Area Network Speed/DisablePage Trunk Setting Mirror SettingQoS Setting PoE Setting Device Status Statistic System Setting Trap Setting Abnormal* 50 error packet count within 10 secondsSet Password Backup Setting Reset SettingLogout LogoutPage Technical Specifications GeneralPhysical and Environmental