LevelOne LevelOne 8+8 POE 10/100 Mbps Web Smart Switch, FSW-1670TX user manual Device Status

Page 35

Figure 26.

Press “Refresh” button to refresh the status of the PoE.

Press click on the ID parameter to enter to the selected port to configure the PoE settings, select enable to activate the PoE function from port 1 to port 8, and disable to deactivate the PoE function. Click “Apply” button to save the setting.

Figure 27.

Device Status

Click on the “Status” to present the device status on this screen, it will show the System Status, Port Status, VLAN Status, Trunk Status, Mirror Status, QoS Status and PoE Status.

Press “Refresh” when you need to renew the posted information.

31

Image 35

Contents LevelOne FSW-1670TX Page Table of Content Installing the Web Management Utility Terms/Usage About this GuidePurpose Page Fast Ethernet Technology IntroductionSwitching Technology Vlan Virtual Local Area Network Power over Ethernet PoEFeatures Unpacking Unpacking and InstallationInstallation Rack Mounting Mount the Switch in the rackAC Power Connecting Network CablePage Front Panel Identifying External ComponentsEthernet Ports Port 9~16 Rear PanelPorts 1~8 PoE port status LEDs Understanding LED IndicatorsPower and System LEDs 100Mbps Ports 9~16 Ethernet port status LEDsInstalling the Web Management Utility ConfigurationDiscovery List System word definitions in the Discovery List Monitor ListPage Device Setting Toolbar Configuring the Switch Login Device Status Configuring Setup Setting Setup MenuPort Settings Speed/Disable Vlan Settings Virtual Local Area NetworkPage Mirror Setting Trunk SettingQoS Setting PoE Setting Device Status Statistic System Setting Abnormal* 50 error packet count within 10 seconds Trap SettingSet Password Reset Setting Backup SettingLogout LogoutPage General Technical SpecificationsPhysical and Environmental