LevelOne LevelOne 8+8 POE 10/100 Mbps Web Smart Switch, FSW-1670TX user manual QoS Setting

Page 33

RX (receive) mode: this mode will duplicate the data that send to the source and forward to the sniffer port.

Both (transmit and receive) mode: this mode will duplicate both the data transmit from and data that send to the source port, then it will forward to the sniffer port.

Figure 21.

QoS Setting

There are three selections in QoS setting, Disable QoS, Port Based and IEEE 802.1p Based.

Figure 22.

Disable QoS: to disable the QoS function of the Switch.

Figure 23.

29

Image 33

Contents LevelOne FSW-1670TX Page Table of Content Installing the Web Management Utility About this Guide PurposeTerms/Usage Page Fast Ethernet Technology IntroductionSwitching Technology Vlan Virtual Local Area Network Power over Ethernet PoEFeatures Unpacking and Installation InstallationUnpacking Rack Mounting Mount the Switch in the rackAC Power Connecting Network CablePage Front Panel Identifying External ComponentsEthernet Ports Port 9~16 Rear PanelUnderstanding LED Indicators Power and System LEDsPorts 1~8 PoE port status LEDs 100Mbps Ports 9~16 Ethernet port status LEDsInstalling the Web Management Utility ConfigurationDiscovery List System word definitions in the Discovery List Monitor ListPage Device Setting Toolbar Configuring the Switch Login Device Status Configuring Setup Setting Setup MenuPort Settings Speed/Disable Vlan Settings Virtual Local Area NetworkPage Mirror Setting Trunk SettingQoS Setting PoE Setting Device Status Statistic System Setting Abnormal* 50 error packet count within 10 seconds Trap SettingSet Password Reset Setting Backup SettingLogout LogoutPage General Technical SpecificationsPhysical and Environmental