Lennox Hearth D2 warranty Problem Questions to Ask, Possible Solutions

LaCie d2 SCSI AIT Drive		Troubleshooting
		page 20
The Problem	Questions to Ask	Possible Solutions

The drive is not recognized.

Is there a conflict with other device	Contact LaCie Technical Support.
drivers or extensions?

Does your computer’s configuration meet the minimum system requirements for use with this drive?

Check section 2.1 Minimum System Requirements.

Are you powering on the SCSI peripherals before the computer?

You must power on all SCSI peripherals connected to your computer before turning on the computer. Otherwise, the SCSI peripherals will not be recognized.

Is the drive’s SCSI ID number the same as that of another device on the SCSI chain?

Check the ID numbers of all devices in your SCSI chain and change them if necessary. Each device must have an individual number, i.e. if you had an external CD-RW, a Hard Drive and Tape drive connected on the same SCSI chain, you would have the CD-RW ID set at 1, the Hard Drive set at 2 and the Tape drive at 3, or similar.

Is the terminator on the drive set correctly? Check the terminator. It should be attached for an LVD/Wide drive only if it is the last device in your SCSI chain. Otherwise, it should not be attached.

Are the pins and holes in the SCSI connectors straight and not deformed?

Turn off your computer and SCSI peripherals and check the cables and connectors. Replace the cables if necessary.