Lennox Hearth D2 warranty Setting Up Your LaCie U&I AIT Drive, Installing Your LaCie AIT Drive

3. Setting Up Your LaCie U&I AIT Drive

Connecting the AC Adapter

To operate the drive, you must use the AC adapter supplied with it.

Warning! Use only the AC adapter supplied with your LaCie drive. Using any other power cable may cause damage to the device and void your warranty.

You may use your LaCie drive when in a foreign country, thanks to its auto-switching 100-240 Volt power supply. To be able to use this feature, you may need to purchase an appropriate adapter. Consult LaCie Technical Support for assistance in choosing the right adapter. LaCie accepts no responsibility for any damage to the drive resulting from the use of an inappropriate adapter. Using an adapter other than one authorized by LaCie will void your warranty.

Connecting the AC Adapter to the Drive

1)Insert the round, four-pin metallic plug of the AC cable into the power input located at the rear of the drive.

2)Connect the wall-side plug to a power socket.

Disconnecting the AC Adapter from the Drive

1)Turn the drive off and wait for it to spin down (+/- 10 sec.).

2)Hold the drive steady with one hand, then remove the plug from the connector.

Warning! Always remove the AC adapter before transporting your LaCie drive. Failure to remove the adapter may result in damage to your drive and will void your warranty.

3.1 Installing Your LaCie AIT Drive

There are five main steps to this installation process:

3.1.1- Software Installation

3.1.2- SCSI Card Verification

3.1.3- Setting the SCSI ID Number

3.1.4- Connecting the Drive to the Computer

3.1.5- Drive Recognition

3.1.1- Software Installation

In order to use your LaCie AIT drive, you will need to first install application software. Unlike a hard disk, CD-R/RW or DVD-RAM/R/RW drive, the AIT drive will not be displayed on your Windows or Mac desktop, and will not be attributed a