LevelOne WAB-1000 manual

Page 16

The WAN port is used to connect the WAB-1000 to the organization’s LAN. The Ethernet cable is run from the WAB-1000 WAN port to the power injector which is then connected to a power source and the wired LAN. A second (LAN Port) Ethernet connector is designed for use during initial configuration only. This uses an RJ45 cable to connect the WAB-1000 to a laptop. The reset button is for set the WAB-1000 to the factory default. Pleasekeep pressing the button and hold for 5seconds, after WAB-1000 restart successfully, the resetting is completed.

The following diagram demonstrates the setup.

11

Image 16

Contents User Guide Page Table of Contents WPA Encryption Page Basic Features IntroductionWireless Basics Network Configuration Access point configurations802.11b 802.11gPossible AP Topologies Bridging Data Encryption and SecurityWPA with TKIP/ AES-CCMP AES-ECB and 3DES for BridgingOperator Authentication and Management MAC Address AuthenticationDhcp Server Management Hardware installation Preparation for useEnsure the cabling is correctly installed Installation InstructionsMinimum system and component requirements Page Indicator Lights Sealing Antenna ConnectionsLED WANPreliminary configuration steps IntroductionInitial setup using the Local port System Configuration GeneralWAN LAN Wireless Setup Page RTS DtimEncryption SsidWPA Encryption Page MAC Address Filtering Bridging and Bridging Encryption Rogue AP Detection Advanced Services Settings Snmp Agent User Management List All UsersMonitoring/Reports Add New UserSystem Status Bridging StatusWireless Clients Adjacent AP List Dhcp Client ListWeb Access Log System LogNetwork Activity Firmware Upgrade System AdministrationFactory Default Reboot Remote LoggingUtilities Configure the WAB-1000 as a bridge General bridge setupPage Page Set up bridging type Point-to-point bridge configurationPoint-to-point bridging setup guide BssidPage Page Point-to-multipoint bridge configuration Point-to-multipoint bridging setup guide Repeater bridge configuration Repeater bridging setup guideBridging Encryption Radio Frequency Interference Requirements Manufacturer’s StatementChannel Separation and Wlan Cards 3DES AESSnmp DhcpTkip WPA