LevelOne WAB-1000 manual Set up bridging type, Point-to-point bridge configuration

Page 48

The following sections describe the setup for three types of bridging configuration: point-to- point, point-to-multipoint, or, lastly, repeater.

Set up bridging type

Point-to-point bridge configuration

A point-to-point link is a direct connection between two, and only two, locations or nodes. Because the WAB-1000’s bridge function uses a separate WLAN card for bridging, you can also set up WLANs on the separate AP WLAN card.

43

Image 48

Contents User Guide Page Table of Contents WPA Encryption Page Basic Features IntroductionWireless Basics Network Configuration Access point configurations802.11b 802.11gPossible AP Topologies Bridging Data Encryption and SecurityWPA with TKIP/ AES-CCMP AES-ECB and 3DES for BridgingMAC Address Authentication Operator Authentication and ManagementDhcp Server Management Hardware installation Preparation for useInstallation Instructions Ensure the cabling is correctly installedMinimum system and component requirements Page Indicator Lights Sealing Antenna ConnectionsLED WANPreliminary configuration steps IntroductionInitial setup using the Local port System Configuration GeneralWAN LAN Wireless Setup Page RTS DtimEncryption SsidWPA Encryption Page MAC Address Filtering Bridging and Bridging Encryption Rogue AP Detection Advanced Services Settings Snmp Agent User Management List All UsersMonitoring/Reports Add New UserSystem Status Bridging StatusWireless Clients Adjacent AP List Dhcp Client ListWeb Access Log System LogNetwork Activity System Administration Firmware UpgradeFactory Default Reboot Remote LoggingUtilities Configure the WAB-1000 as a bridge General bridge setupPage Page Set up bridging type Point-to-point bridge configurationPoint-to-point bridging setup guide BssidPage Page Point-to-multipoint bridge configuration Point-to-multipoint bridging setup guide Repeater bridge configuration Repeater bridging setup guideBridging Encryption Manufacturer’s Statement Radio Frequency Interference RequirementsChannel Separation and Wlan Cards 3DES AESDhcp SnmpTkip WPA