Navigate to the Wireless
In the first section: General, you will see the MAC address of the bridging card. This is used as the BSSID on other
Wireless mode can be set to 802.11g for best rate, to 802.11b (if necessary) or to mixed 802.11b/g. Set basic and supported rates. Channel number must be set the same for each bridge to communicate. TX Pwr mode can be left on auto unless the power needs to be regulated. Set Spanning Tree Protocol to enable unless you are sure that there is no chance of a loop.
Bridge signal strength LED port allows you to set the number of one of the remote APs which will be listed in section 3 at the bottom of the screen once the system is operational as the guiding port that you wish to have display in the WLANSS LED on the front of the
Click Apply to accept your changes but remain on that screen.
In the second section on the Wireless
45