LevelOne WAB-1000 manual Repeater bridge configuration, Repeater bridging setup guide

Page 54

Wireless Configuration – Bridging Encryption

Select appropriate key

Select appropriate key

 

type/length and value. Must

type/length and value.

 

be the same key as Bridge

Must be the same key as

 

2~n.

Bridge 1.

 

 

 

 

 

 

The above recommended setup requires only Bridge 1 to be set in point-to-multipoint mode. It is possible to set all bridges in point-to-multipoint mode, in which case, each bridge would have to contain the BSSID for each of the other bridges and Spanning Tree Protocol must be enabled.

As stated previously, complete any other setup screens following general instructions in Chapter 3.

Repeater bridge configuration

A repeater setup can be used to extend the wireless signal from one bridge connected to an Ethernet LAN wirelessly so that another bridge can control a wireless LAN at a distance.

Repeater bridging setup guide

Direction

Bridge 1

Bridge 2

Bridge 3

 

 

 

 

Wireless Configuration – General

 

 

 

 

 

 

SSID

default (or set for 802.11b/g

default (or set for

default (or set for

 

WLAN)

802.11b/g WLAN)

802.11b/g WLAN)

 

 

 

 

Channel

11

11

11

 

 

 

 

Wireless Configuration –

Select appropriate key type

Select appropriate key

Select appropriate key

Encryption

and length and enter key

type and length and enter

type and length and

 

value

key value

enter key value

 

 

 

 

Wireless Configuration – Bridging

 

 

 

 

 

 

Channel

4

4

4

 

 

 

 

Tx Power Mode

Auto

Auto

Auto

 

 

 

 

 

 

 

 

49

Page 53 Page 55
Image 54
Page 53 Page 55
Contents User Guide Page Table of Contents WPA Encryption Page Basic Features IntroductionWireless Basics 802.11b Network ConfigurationAccess point configurations 802.11gPossible AP Topologies Bridging Data Encryption and SecurityWPA with TKIP/ AES-CCMP AES-ECB and 3DES for BridgingMAC Address Authentication Operator Authentication and ManagementDhcp Server Management Hardware installation Preparation for useInstallation Instructions Ensure the cabling is correctly installedMinimum system and component requirements Page LED Indicator LightsSealing Antenna Connections WANPreliminary configuration steps IntroductionInitial setup using the Local port System Configuration GeneralWAN LAN Wireless Setup Page RTS DtimEncryption SsidWPA Encryption Page MAC Address Filtering Bridging and Bridging Encryption Rogue AP Detection Advanced Services Settings Snmp Agent User Management List All UsersMonitoring/Reports Add New UserSystem Status Bridging StatusWireless Clients Adjacent AP List Dhcp Client ListWeb Access Log System LogNetwork Activity System Administration Firmware UpgradeFactory Default Reboot Remote LoggingUtilities Configure the WAB-1000 as a bridge General bridge setupPage Page Set up bridging type Point-to-point bridge configurationPoint-to-point bridging setup guide BssidPage Page Point-to-multipoint bridge configuration Point-to-multipoint bridging setup guide Repeater bridge configuration Repeater bridging setup guideBridging Encryption Manufacturer’s Statement Radio Frequency Interference RequirementsChannel Separation and Wlan Cards 3DES AESDhcp SnmpTkip WPA
Top Page Image Contents