LevelOne WAB-1000 manual Lan

Page 22

If not using DHCP to get an IP address, input the information that the access point requires in order to allow the wireless devices it controls access to the wired LAN. This will be the IP address, Subnet Mask, Default Gateway, and, where needed, DNS 1 and 2.

Click Apply to accept changes.

LAN

This sets up the default numbers for the four octets for a possible private LAN function for the access point. It also allows changing the default numbers for the LAN Subnet Mask. The Local LAN port provides local access for configuration. It is not advisable to change the private LAN address while doing the initial setup as you are connected to that LAN.

17

Image 22

Contents User Guide Page Table of Contents WPA Encryption Page Basic Features IntroductionWireless Basics 802.11b Network ConfigurationAccess point configurations 802.11gPossible AP Topologies Bridging Data Encryption and SecurityWPA with TKIP/ AES-CCMP AES-ECB and 3DES for BridgingOperator Authentication and Management MAC Address AuthenticationDhcp Server Management Hardware installation Preparation for useEnsure the cabling is correctly installed Installation InstructionsMinimum system and component requirements Page LED Indicator LightsSealing Antenna Connections WANPreliminary configuration steps Introduction Initial setup using the Local port System Configuration GeneralWAN LAN Wireless Setup Page RTS DtimEncryption SsidWPA Encryption Page MAC Address Filtering Bridging and Bridging Encryption Rogue AP Detection Advanced Services Settings Snmp Agent User Management List All UsersMonitoring/Reports Add New UserSystem Status Bridging StatusWireless Clients Adjacent AP List Dhcp Client ListWeb Access Log System LogNetwork Activity Firmware Upgrade System AdministrationFactory Default Reboot Remote LoggingUtilities Configure the WAB-1000 as a bridge General bridge setupPage Page Set up bridging type Point-to-point bridge configurationPoint-to-point bridging setup guide BssidPage Page Point-to-multipoint bridge configuration Point-to-multipoint bridging setup guide Repeater bridge configuration Repeater bridging setup guideBridging Encryption Radio Frequency Interference Requirements Manufacturer’s StatementChannel Separation and Wlan Cards 3DES AESSnmp DhcpTkip WPA