Lava Computer 800, lava paylink-ip/dial manual Hardware Setup

2Hardware Setup

1.Connect the power supply to the LAVA PayLink-IP/Dial and to AC power. The power (red) LED will light to indicate that the unit is receiving power.

2.Connect an Ethernet cross-over cable to the Ethernet RJ-45 jack of the LAVA PayLink-IP/Dial. Attach the other end of the crossover network cable to a host PC directly.

Network status is indicated by two LEDs on the RJ-45 connector. The left (yellow) LED indicates network activity. It is on by default, turning off when network activity occurs at the PayLink-IP. The right (green) LED indicates a network link. It is off by default, but lights when a network link exists.

Network

Activity and Link

indicators

Network connector (RJ-45)

Power	Power
indicator	connector