LevelOne GSW-1601TX, GSW-2401TX user manual Troubleshooting, Solution

Page 37

Troubleshooting

This chapter contains information to help you solve problems. If LevelOne GSW-1601/2401TX 16/24 Port 10/100/1000Mbps Switch with Gigabit option is not functioning properly, make sure the Ethernet Switch was set up according to instructions in this manual..

•The Link LED is not lit

Solution:

Check the cable connection and remove duplex mode of LevelOne GSW-1601/2401TX 16/24 Port 10/100/1000Mbps Switch with Gigabit option

•Some stations can not talk to other stations located on the other

port

Solution:

The address table may contain older information than of the address table of that node. Please power down to refresh the address information.

31

Image 37

Contents Vision FCC Class a Appliance Contents Troubleshooting Package List Page Features Page 24Port 10/100Mbps Switch with Gigabit option Port 10/100Mbps Switch with Gigabit optionPort 10/100Mbps Switch front panel Twisted-Pair Ports AC Power ConnectorReset Switch LED IndicatorsConnecting End node or Hub or Switch Power LED Connecting to Network Backbone or ServerLabel L10/ L100/ L1000 Link/ Speed LEDFull/ Half Duplex and Collision LED TX ActivityHyper Terminal Connect to PC RS-232 serial cableMain Menu Speed Mode Page Address Learn Vlan Type ‘S’ or ‘s’ than input ‘2’ ,press Enter Select c Please Wait Queues Priority Trunk Type ‘A’ or ‘a’ three times to assigned trunk port member SelectType ‘E’ or ‘e’ return to main menu Input ‘1’ and press Enter Uplink PortType ‘C’ or ‘c’ to continue Select 16-P 10/100M + 2-P 1GCOOPER Module ver3.12 UpLink Group 2 ,assigned ports Monitor Port Type ‘E’ or ‘e’ back to main menu View Configuration Restore To Factory Default Address Table Switch OperationLearning Forwarding & FilteringAuto-Negotiation Store-and-ForwardSolution TroubleshootingEchnical Specifications RJ-45 Connector pin assignment RJ-45 P in Specification