LevelOne GSW-2401TX, GSW-1601TX user manual FCC Class a Appliance

Page 2

FCC Class A Appliance

This equipment generates and uses radio frequency energy. If it is not installed and used properly in strict accordance with the manufacturer‘s instructions, it may cause interference to radio and television reception. It has been type-tested and found to comply the specifications in sub-part J of Part 15 of FCC Rules, which are designed to provide reasonable protection against such interference in a residential installation. There is no guarantee that interference will not occur in a particular installation. If this equipment does cause interference to radio or television reception which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Re-orient the receiving antenna

Relocate the computing device with respect to the receiver

Move the computer away from the deceiver

Plug the computer into a different outlet so that compute and receiver are on different electrical circuits.

If necessary the user should consult the dealer or an experienced radio or television technician for additional suggestions.

The information in this manual is subject to change without notice. All the brand names are registered trademarks of their respective companies

Image 2
Contents Vision FCC Class a Appliance Contents Troubleshooting Package List Page Features Page Port 10/100Mbps Switch front panel Port 10/100Mbps Switch with Gigabit option24Port 10/100Mbps Switch with Gigabit option AC Power Connector Twisted-Pair PortsConnecting End node or Hub or Switch LED IndicatorsReset Switch Connecting to Network Backbone or Server Power LEDFull/ Half Duplex and Collision LED Link/ Speed LEDLabel L10/ L100/ L1000 TX ActivityConnect to PC RS-232 serial cable Hyper TerminalMain Menu Speed Mode Page Address Learn Vlan Type ‘S’ or ‘s’ than input ‘2’ ,press Enter Select c Please Wait Queues Priority Trunk Select Type ‘A’ or ‘a’ three times to assigned trunk port memberType ‘E’ or ‘e’ return to main menu Uplink Port Input ‘1’ and press EnterType ‘C’ or ‘c’ to continue Select 16-P 10/100M + 2-P 1GCOOPER Module ver3.12 UpLink Group 2 ,assigned ports Monitor Port Type ‘E’ or ‘e’ back to main menu View Configuration Restore To Factory Default Learning Switch OperationAddress Table Forwarding & FilteringStore-and-Forward Auto-NegotiationTroubleshooting SolutionEchnical Specifications RJ-45 P in Specification RJ-45 Connector pin assignment