IMC Networks Giga-AcessEtherLinx-II operation manual DC Power Supply Wiring Instructions

Page 34

Strongly recommended:

128 MB RAM

Pentium III 650Mhz or Faster

17” Monitor @ 1024 x 768 Resolution or higher

Installing and Using iView²

iView² is available to install as a download at www.imcnetworks.com/Products/iView.cfm.

When using iView² with HP OpenView

During the installation, the iView² application will ask if HP Open View is installed on the management PC. Click Yes to integrate the appropriate files. Once in OpenView, select IMC Networks from the toolbar to view the IMC Networks devices.

When Not Using iView²

When using an application other than iView² for management, integrate the SNMP vendor files (a.k.a. MIBs) into the application. The SNMP agent uses the following Enterprise-specific MIB file and standard MIBs, which can be found in the MIB directory within the iView² download files.

Using the IMC MIBs

Refer to the MIBs folder located with the iView² software for product-related MIBs.

DC Power Supply Wiring Instructions

DC Power Supply

DC Power Supply

If in a -48 environment:

If in a +48 environment:

GND

 

 

-48

 

+48

 

 

GND

(Common)

 

Chassis

 

 

 

Chassis

 

(Common)

 

 

Gnd

 

 

 

Gnd

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Terminal Block

 

 

 

Terminal Block

 

NOTE

Incorrect wiring will result in chassis malfunction. The Giga-AccessEtherLinX-II (DC) is compliant with Isolated Grounding Plane practices. The POSITIVE and NEGATIVE terminals are isolated from chassis ground and must have a ground reference at the power-sourcing equipment.

31

Image 34
Contents Giga-AccessEtherLinX-II Warranty FCC Radio Frequency Interference StatementTable of Contents About the Giga-AccessEtherLinX-II Installing the Giga-AccessEtherLinX-IIAutoCross Feature for Twisted Pair Connection Rackmount InstallationFeatures Two Layer Qualified Q-in-Q Support Software Configurable FeaturesPriority Queuing and Flow Control IP-Less Management in HOST/REMOTE configurationsAuto Negotiation, Duplex Mode and Speed Bandwidth ControlUtility iConfig About iView² Unit ManagementAbout Console Port Configuration SNMP, Telnet and Console ManagementMain Configuration Screen Command ListAssigning IP Information Deleting Community Strings Ifstats Version Pre Configured Modes Configuring VLANsQualified Vlan Settings Downloading FilesVlan Mode Screen Mode 1-Untagged Frames Only Mode 3- Mixed Tagged and Untagged, Block Mgmt Domain Only untagged frames are delivered to the Downlinks Page Mode 6-Port Based Extra Tag Page Mode 7- Port Based Extra Tag, Infrastructure Page Page Mode 8-VLAN Assigned Unit Control Settings Bandwidth Limiting Port Configuration System Descriptions Firmware and Unit Version InformationUpdate Manager Using ManagementUsing iView² with HP OpenView Other NMS ApplicationsIP-Less Management With the Unified Management AgentFile Management for Upgrading Using Telnet LED Operation Downlink PortsBefore using iView² PasswordsUplink Ports DC Power Supply Wiring Instructions DC Power SupplyRackmount Precautions DC Power Supply Precautions Specifications Standards IMC Networks Technical SupportFiber Optic Cleaning Guidelines Electrostatic Discharge PrecautionsSafety Certifications Document Number 52-80321-00 A1