Invacare SP manual Footboard Assembly, Removing/Installing the Footboard

SECTION 8—FOOTBOARD ASSEMBLY

SECTION 8—FOOTBOARD

ASSEMBLY

WARNING

After ANY adjustments, repair or service and before use, make sure that all attaching hardware is tightened securely - otherwise injury or damage may result.

Before performing any maintenance, adjustment or service, verify that ON/OFF switch on the joystick is in the OFF position.

DO NOT stand on the flip-up footboard. When getting in or out of the wheelchair, make sure that the flip-up footboard is in the upward position.

LIMITED CLEARANCE BETWEEN FOOTBOARD AND CASTER - The user’s feet MUST remain on the footboard while operating the wheelchair. If the user’s feet are allowed to rest off the side of the footboard they may come in contact with the caster possibly resulting in injury.

Removing/Installing the Footboard

NOTE: For this procedure, refer to FIGURE 8.1 on page 51.

Removing

1.Remove the socket heat screw, three washers, spacer and locknut that secures the footboard to the footboard support.

2.Remove the footboard from the footboard support.

Installing

WARNING

Pinch point may occur when rotating the footboard assembly.

1.Position the footboard onto the footboard support so that the mounting holes in the wheelchair frame align with the desired mounting holes in the footboard support.

2.Using the socket heat screw, three washers, spacer and locknut secure the footboard to the footboard support.

TDX™ SP 50 Part No 1143190