SECTION
|
| Footboard Support | |
|
| Washers | |
|
| Socket Head | |
|
| Screw | |
Washer |
|
| |
Spacer |
| Footboard | |
Locknut | Assembly | ||
|
FIGURE 8.1 Removing/Installing the Footboard
Adjusting the Footboard Angle
NOTE: For this procedure, refer to FIGURE 8.2.
1.Loosen the jam nut and set screw located underneath on the rear of the footplate.
2.Adjust the mounting screw in or out to obtain the desired footboard angle.
3.Thread the jam nut inward until it is flush with the footboard bracket.
4.Securely tighten the jam nut and washer to secure the mounting screw in place.
Part No 1143190 | 51 | TDX™ SP |