Intellinet Network Solutions 509077 user manual System Configuration

4.7 System Configuration

Double-click the System icon to display the System configuration screen, where you can see all available printing protocols and upgrade the firmware.

Port Name: You can name the port the MFP server connects to. The default port name is ‘’p1.’’

Upgrade Firmware: You can use this Upgrade Firmware tool to upload the newest firmware for the MFP server. Click and select the correct firmware in your PC. After selecting the firmware file, click “Upgrade” to finish the firmware update process. NOTE: Before you upgrade the firmware, make sure the IP address settings of the MFP server are in the same network as your computer.

Load Default: Click to reset the MFP server to default factory settings.

Wireless Function: Select “Auto,” “Enable” or “Disable” to manually configure the wireless function.

•“Auto” is the default setting of the MFP server. In this mode, the MFP server will automatically decide to enable or disable the wireless function. When the MFP server starts up, it will auto-detect if the LAN port is connected to an active network by an Ethernet cable. If this is the case, the MFP server will run in Ethernet mode. If the MFP server is not connected to an active network by an Ethernet cable, the MFP server will run in wireless LAN mode.

You can plug the Ethernet cable into the MFP server, then, after configuring the MFP server features and wireless settings, unplug the Ethernet cable to enable the wireless connection. This makes the configuration much easier without creating the wireless connection in advance. NOTE: After setting the wireless function, remove the Ethernet cable and then remove and re-connect the power cable of the MFP server to activate the wireless connection.

SERVER CONFIGURATION 23