Kingston Technology KNS800/WG Link / Activity LED, Full Duplex and Collision LED, Cascade Switch

Page 10

6

Front Panel

Link / Activity LED

The LINK/ACT LED uses a single LED to display two functions. A steady green light indicates that a good link has been established, and a flashing green light indicates when data is being received or transmitted. If the LED does not display solid green indicating a good link, check the following:

1.Make sure that the power is turned on for both the Fast EtheRx Switch and the attached device.

2.Verify that the drivers for the network adapter have been loaded on the PC. Some network adapters require that the driver be loaded before establishing a proper link.

3.Make sure the cable is wired properly and connected on both ends.

4.Make sure the correct cable type has been selected.

5.If steps 1 through 4 are correct, please check the cable, as it may be defective or wired incorrectly. Replace the cable and try again. Please refer to Appendix A for Pin Assignments and Appendix B for Cabling Guidelines.

Full Duplex and Collision LED

The FDX/COLL LED uses a single color LED to display two functions. A solid green light indicates that Full-Duplex operation has been detected. A flashing amber light indicates that a collision has occurred in half-duplex mode. Full-Duplex mode is auto-negotiated on all UTP ports.

Cascade Switch

The cascade position marked “ ” configures the last UTP port (port 5 on the KNS500/WG or port 8 on the KNS800/WG) as internally-crossed like all other UTP ports. By default, all repeater and switched UTP ports are generally configured as standard MDI-X, or internally-crossed ports. With a straight- through cable, this port can be used for cascading to a standard MDI device, such as a network adapter or router. With a crossover cable, this port can be used for cascading to another MDI-X device, such as a hub or switch.

The cascade position marked “ ” configures the last UTP port (port 5 on the KNS500/WG or port 8 on the KNS800/WG) as straight-through. With a crossover cable, this port can be used for cascading to another MDI device, such as a network adapter or router. With a straight-through cable, this port can be used for cascading to an internally-crossed MDI-X device, such as a hub or switch.

Kingston Technology Company

KNS800/WG User’s Guide – Rev.B01

Image 10
Contents 10/100TX Workgroup Kingston Technology’s Fast EtheRx Port & 8-Port 10/100TX Workgroup Fast Ethernet Switch User’s GuidePart No -001.B01 Able Ontents Appendix a Introduction Model Types Model KNS500/WGSpecial Features Package ContentsDesign Features Front Panel Hardware InstallationPower LED 100TX Speed Detection LEDLink / Activity LED Cascade SwitchFull Duplex and Collision LED Using a Straight-Through Cable Rear Panel Power Connector10/100TX UTP Ports Appendices Appendix a Pin Assignments UTP Port Pin AssignmentsAppendix B Cabling Guidelines UTP Cable WiringUTP Cable Type UTP Cable Wiring Standards T568A T568BUTP Cable Rating Codes Terms You Should Be Familiar WithSpecifications Appendix CFast EtheRx Model KNS800/WG Appendix D Frequently Asked Questions What is a switch and what does it do?Category 5 Compliance vs. Category 5 Performance? Duration of Warranty Limited Warranty StatementAppendix E Warranties and Notices Free Technical Support Warranty Claim RequirementsDisclaimers CE Notice C. CertificationTick Certification