Wolfcraft 6155, 6156 manual Operation of Switch Box and Router, For Routers With LOCK-ON Feature

Operation of Switch Box and Router

Make sure router switch WARNING is OFF and switch box is

OFF BEFORE proceeding.

1.Insert the yellow safety key into the switch box.

2.Position router power switch to ON.

NOTE: If your router requires the use of the switch trigger and "Lock-On" button, refer to your Router Owner's Manual for operating instructions.

3.Insert finger under paddle and pull out switch to ON position.

4.To turn router OFF push paddle in.

Router bit must come to a WARNING complete stop before

leaving router table unattended.

5.Lock switch to OFF position by removing key from switch box.

For Routers With "LOCK-ON" Feature

The "LOCK-ON" feature on some routers will not permit the router to be turned ON by the switch box, but it can be turned OFF by the switch box.

1.Place the switch box to ON as previously described. The router should NOT start even though the trigger lock is in the "LOCK-ON" position. Refer to your router table Owner's Manual.

2.To start router, depress trigger on router switch and engage "LOCK-ON" button. Router should start.

NOTE: Typically, a router will not start if the router switch is already in the "LOCK-ON" position. In this case, unlock the trigger, depress the trigger to start the router, then re-engage the "LOCK-ON" button.

3.To turn router OFF, push switch paddle in.

Circuit Breaker

If an overload occurs, the circuit breaker inside the Switch Box trips and interrupts power to the router and any accessories. If this happens:

1.Unplug the power cord.

2.Remove the workpiece from the router bit and table.

3.Find the cause of the overload and correct.

4.Push the reset button to reset it. See Figure 29.

5.Plug in power cord.

6.Follow instructions under Operation of Switch Box and Router to reset router.

OUTLETS

PULLO

PUSHN

OF

RESETF

reset button

Figure 29

29