Wolfcraft 6155, 6156 manual Mounting the Router, Hole Router Brand Specific Model

MOUNTING THE ROUTER

Always remove router bits WARNING and unplug router before

mounting to router table.

The table will accept routers with bases up to 7" in diameter. There are two methods for attaching routers to router table.

Hole	Router Brand/	Specific Model
Pattern	Hole Use	Numbers
A	Square Adaptor Plate	Most routers
	Mounting Holes	mount with plate
B	Ryobi	#R160K, #R160V,
		#R165, #R180
	Craftsman	#27500, #27510,
		#27511
C	Ryobi	#R174, #RE175
D	Porter Cable	#690, #6931
E	Skil	#1823, #1835,
		#1845-02,
	Craftsman	#17504, #17505,
		#17506
F*	Dremel™ Rotary	All
	Hobby Tools
G	Threaded Hole for	n/a
	Pilot Pin
H	Pilot Pin Storage Hole	n/a
	Dovetail/Box Joint
J	Fixture Mounting Slots	n/a

Dremel™ is a registered trademark of S-B Power Tool Company.

*Mounts with Dremel™ #330 Router Attachment Kit (not included, see below).

At least three holes should be aligned for proper support of the router. If fewer than three holes line up, follow instructions on how to mount your router with the square adaptor base plate (Z) on the next page.

H

J

AA

B/C D B

E FF E

G

D D

B/C

E

A B A

J

Figure 18

If your router is not one of those listed in the chart, place the router base plate on top of the router table and rotate the base plate until the holes are aligned. When the two hole patterns line up, your mounting pattern has been identified. See Figure 18.

21